In short
A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Glen Ridge, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Doors that won't close in Glen Ridge
Glen Ridge is a narrow borough of historic houses, gas street lamps and slate sidewalks. Around the historic center and along the Glen, Victorian and early-1900s homes have carriage houses and detached garages at the rear, reached by long narrow drives. The buildings are old wood on settled foundations, and sensors mounted to them move out of line with the seasons. On the northern and southern streets, slightly later houses have small single garages. Near the train station, lots are tightest. With gas lamps and little other light, a blocked sensor is hard to see at night, so check with a flashlight.
Why a garage door refuses to close
- Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
- Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
- Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
- Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.
Three safe checks before you call
- Look at the small lights on both sensors. Each should be on and steady.
- Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
- Gently turn the blinking sensor until its light goes steady, then try the remote again.
If that doesn't do it, stop there. Don't tape the sensors together or bypass them.
How the repair is done
The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.
Around Glen Ridge
- Southern streets: Near Bloomfield Avenue, with older homes on tight lots.
- Train station area: Near the Glen Ridge and Bay Street stations, with mixed housing.
See the full Glen Ridge service area.